VRS07 Master Bedroom
28mm Scale.Resin & Brass models.
Foamboard or Foamcard NOT INCLUDED
Master Bedroom. Recommended dimensions. 5mm Foam-card or board. Floor, 200mm x140mm.
Rear Wall 200mm long x 85mm high. You will need to cut in the centre a 38mm by 2mm slot, 5mm above the bottom edge & directly above that in the centre a 26mm long x 20mm rectangle to fit the fireplace in properly, so that it sits on the floor and slots into the wall.
Side wall 140 mm wide x 85mm. You will need to cut a 28mm wide x 40mm hole 5mm above the bottom edge to accommodate the door. You can place the door where you think best. The one in the picture was cut 15mm from the left. Also think about whether this wall will be placed on the left or right hand side, depending on the overall layout of the building you have in mind.
Contents
1x Large Double Bed
1x Decorative fire place and log insert
2x Large Wardrobes
2x Bedside Cabinets
2x Lamps
1x Chaise Longue
1x Round Table
1x Large Sofa
1x Large Armchair
1x Dressing Table & Chair
1x Door
1x Large picture frame
1x Small picture frame
Individual items would cost £39.00
The Figure is a 28mm Royal Naval Officer from COPPLESTONE CASTINGS & is available from Northstar Figures