VRS04 Morning room
28mm Scale.Resin & Whitemetal models.
Foamboard or Foamcard NOT INCLUDED
Morning Room. Recommended dimensions. 5mm Foam-card or board. Floor, 150mm x140mm.
Rear Wall 150mm long x 85mm high. You will need to cut in the centre a 38mm by 2mm slot, 5mm above the bottom edge & directly above that in the centre a 26mm long x 20mm rectangle to fit the fireplace in properly, so that it sits on the floor and slots into the wall.
Side wall 140 mm wide x 85mm. You will need to cut a 28mm wide x 40mm hole 5mm above the bottom edge to accommodate the door. You can place the door where you think best. The one in the picture was cut 75mm from the rear wall (overall Length70mm interior length) Also think about whether this wall will be placed on the left or right hand side, depending on the overall layout of the building you have in mind.
1x Victorian Fireplace
1x Sideboard
1x Bureau
1x Georgian Sofa
2x Small armchairs
1x Low rectangle table
1x Rectangle table
1x Small Round table
2x Lamps
2x Greek Urns
1x Door
6x Various size picture frames
Individual items would cost £28.00
The Figure is a 28mm Royal Naval Officer from COPPLESTONE CASTINGS & is available from Northstar Figures