VRS02 The Drawing Room.
28mm Scale.Resin & Whitemetal models.
Foamboard or Foamcard NOT INCLUDED
Drawing Room. Recommended dimensions. 5mm Foam-card or board. Floor, 200mm x140mm.
Rear Wall 200mm long x 85mm high. You will need to cut in the lower middle a 50mm by 2mm slot, 5mm above the bottom edge & directly above that in the centre a 38mm long x 19mm rectangle to fit the fireplace in properly, so that it sits on the floor and slots into the wall.
Side wall 140 mm wide x 85mm. You will need to cut a 28mm wide x 40mm hole 5mm above the bottom edge to accommodate the door. You can place the door where you think best. The one in the picture was cut 75mm from the rear wall (overall interior length70mm) Also think about whether this wall will be placed on the left or right hand side, depending on the overall layout of the building you have in mind.
1x Georgian Fireplace
2x Large Sofa
2x Large Armchairs
1x Low square table
2x Sideboard
1x Cabinet
2x Greek Urns
2x Leather Chairs
1x Large Round Table
1x Grand Piano
1x Bureau
2x Lamps
1x Grandfather Clock
1x Door
6x Various size picture frames
Individual items would cost £45.00
The Figure is a 28mm Royal Naval Officer from COPPLESTONE CASTINGS & is available from Northstar Figures