VF27 Ornamental Fireplace with Chimney breast.
28mm Scale. Resin model.
Designed to be slotted into a 5mm thick foam board interior wall. You will need to cut in the lower middle of the wall a 40mm by 2mm slot, 5mm above the bottom edge & directly above that in the centre a 28mm long x 19mm rectangle to fit the fireplace in properly, so that it sits on the floor and slots into the wall. If you do not wish to cut a hole, use a 5mm thick by 28mm wide by 48mm tall piece of foam card (based on 5mm floor thickness) to attach on the rear of the chimney breast to act as a spacer.
Height 80mm overall, Height to mantelpiece 31mm Width 40mm, (plinth). Depth 15mm (plinth). Recommended foam-card wall height 80mm (Plus 5mm to allow for floor thickness)
The Figure is a 28mm Royal Naval Officer from COPPLESTONE CASTINGS & is available from Northstar Figures