VF26 Decorative Fireplace.
28mm Scale. Resin model.
Designed to be slotted into a 5mm thick foam board interior wall. You will need to cut in the lower middle of the wall a 38mm by 2mm slot, 5mm above the bottom edge & directly above that in the centre a 26mm long x 20mm rectangle to fit the fireplace in properly, so that it sits on the floor and slots into the wall. If you do not wish to cut a hole, use a 5mm thick by 26mm wide by 51mm tall piece of foam card (based on 5mm floor thickness) to represent an interior chimney breast.
Height 26mm, Width 39mm, (plinth). Depth 15mm (plinth). Recommended foam-card wall height 80mm (Plus5mm to allow for floor thickness)
The Figure is a 28mm Royal Naval Officer from COPPLESTONE CASTINGS & is available from Northstar Figures